Custom Pumpout Workboat

Custom Pumpout Workboat - Ready to go to work for you!

Custom-made Workboat / Pumpout boat is ready to go to work in your operation.  She has been used for a marina dock rebuilding project and as a waste pumpout boat.   The pumpout equipment is great for ‘in slip’ boat servicing or it can be removed if you need open deck space.  The all steel hull was custom built by a local marine fabricator in 2008.  She has only seen short seasonal use on the northern Mississippi and never in salt water.

The cost to build was more than twice the asking price.  Offers are encouraged. 

Custom built by River City Welding in 2008

Hull material: 3/16\" Steel

Hull length: 25’

LOA: 27’6”

Width 12’

Motors down draft: 18”

Hull draft approximately 12”

Twin Yamaha 50 HP 4-stroke outboards with power tilt & trim, hydraulic steering and less than 500 hours.

Briggs and Stratton TwinV 23 HP gas engine powers hydraulics

Heavy wood push knee on bow

Hydraulic spud poles on stern (length 29’ and 7” by 7”) with independent hydraulic winches

Hydraulic crane/lift (boom length 20’ and 6” by 5”) with a hydraulic lifting ram and hydraulic winch

Used as a waste pump out boat – two 500 gallon tanks with a Keco Pump-A-Head twin diaphragm vac pump and a Honda engine.  The pumpout equipment is great for ‘in slip’ boat servicing or it can be removed if you need open deck space.

All fittings included and lots of suction hose

Three batteries

Enclosed cab with all controls in easy reach of captain

100 gallon fuel tank feeds both outboards and hydraulic motor.  Separate fuel tank supplies pumpout motor.

Two part epoxy paint on hull

Coal tar epoxy bottom coating

Navigation lights

The owners are very anxious to sell and will consider all offers.

Custom built by River City Welding in 2008

Hull material: 3/16\" Steel

Hull length: 25’

LOA: 27’6”

Width 12’

Motors down draft: 18”

Hull draft approximately 12”

Twin Yamaha 50 HP 4-stroke outboards with power tilt & trim, hydraulic steering and less than 500 hours.

Briggs and Stratton TwinV 23 HP gas engine powers hydraulics

Heavy wood push knee on bow

Hydraulic spud poles on stern (length 29’ and 7” by 7”) with independent hydraulic winches

Hydraulic crane/lift (boom length 20’ and 6” by 5”) with a hydraulic lifting ram and hydraulic winch

Used as a waste pump out boat – two 500 gallon tanks with a Keco Pump-A-Head twin diaphragm vac pump and a Honda engine. The pumpout equipment is great for ‘in slip’ boat servicing or it can be removed if you need open deck space.

All fittings included and lots of suction hose

Three batteries

Enclosed cab with all controls in easy reach of captain

100 gallon fuel tank feeds both outboards and hydraulic motor. Separate fuel tank supplies pumpout motor.

Two part epoxy paint on hull

Coal tar epoxy bottom coating

Navigation lights

Features: